Author Topic: my pen  (Read 4864 times)

Offline dChris

  • *
  • Posts: 1
  • Karma: +0/-0
    • View Profile
on: February 09, 2008, 04:28:22 AM
hi there!

just wanted to show you my pen.

for the pen i used an old deco-marker. unfortunately, there was still a lot of fluid in it. be careful when you open those table is now a bit silver  >:( i used nail laquer remover to get the inside of the marker free from the fluid.

my led is a 100mA, 940nm IR-LED (for all austrians: i got it from conrad)
my power source is a 1.5V AAA-battery, directly connected to the IR. if you use just one battery, you don't need any resistor.
between the battery and the led i soldered a momentary switch. the red knob is from an old laser-pointer.

i needed about 3 hours. but i think you can be a lot faster....most of the time i spend cleaning the damned pen and my desk.


Offline trux93

  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
    • Trux93 world
Reply #1 on: February 09, 2008, 04:52:43 AM
very good Job ;)

Where is My signature ? she is not here !!

Offline ElementalTJ

  • *
  • Posts: 9
  • Karma: +0/-1
    • View Profile
    • Elemental's Upload Manager
Reply #2 on: February 09, 2008, 10:27:02 AM
Very good job. :)
Check out mine. ^^

I probably should've put the topic in the IR Pens
section. I wasn't thinking.  :P